Sony XAV-AX200 Service Manual Download

Page: 17 / 62

XAV-AX200/AX200C2

*1 Not supplied
*2 Speaker impedance: 4 Ω – 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor for a wired

remote control (not supplied).
For details on using the wired remote control, see “Using
the wired remote control” (page 30).

*5 Whether in use or not, route the microphone input cord

so it does not interfere with driving operations. Secure
the cord with a clamp, etc., if it is installed around your
feet.

*6 For details on installing the microphone, see “Installing

the microphone” (page 29).

*7 To connect a smartphone to the main unit, an

appropriate cable (not supplied) is required.

*8 To connect an iPhone, use the USB connection cable for

iPhone (not supplied).

To a common ground (earth) point

First connect the black ground (earth) lead then
connect the yellow and red power supply leads.

To the +12 V power terminal which is
energized at all times

Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.

To the +12 V power terminal which is
energized when the ignition switch is set to
the accessory position

If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energized at all times.
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.

Making connections

(AUS, LA)

Cautions

• Run all ground (earth) leads to a common

ground (earth) point.

• Do not get the leads trapped under a screw or

caught in moving parts (e.g., seat railing).

• Before making connections, turn the car ignition

off to avoid short circuits.

• Connect the

yellow

and

red

power supply leads

only after all other leads have been connected.

• Be sure to insulate any loose unconnected leads

with electrical tape for safety.

• Choose the installation location carefully so that

the unit will not interfere with normal driving
operations.

• Avoid installing the unit in areas subject to dust,

dirt, excessive vibration, or high temperature, such
as in direct sunlight or near heater ducts.

• Use only the supplied mounting hardware for a

safe and secure installation.

Note on the power supply lead (yellow)

When connecting this unit in combination with other stereo
components, the amperage rating of the car circuit to which
the unit is connected must be higher than the sum of each
component’s fuse amperage rating.

Mounting angle adjustment

Adjust the mounting angle to less than 45°.

Connection/Installation

Precautions

To the power antenna (aerial) control lead or
the power supply lead of the antenna (aerial)
booster

It is not necessary to connect this lead if there is
no power antenna (aerial) or antenna (aerial)
booster, or with a manually-operated telescopic
antenna (aerial).

To AMP REMOTE IN of an optional power
amplifier

This connection is only for amplifiers and a
power antenna (aerial). Connecting any other
system may damage the unit.

Note

It will take about 10 seconds to shut down the output of
REM OUT after the unit is turned off.

To a car’s illumination signal

Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.

To the parking brake switch cord

The mounting position of the parking brake
switch cord depends on your car.
Be sure to connect the parking brake lead (light
green) of the power supply connection cable

to the parking brake switch cord.

To the +12 V power terminal of the car’s rear
lamp lead (only when connecting the rear
view camera)

Parking brake switch cord

Hand brake type

Foot brake type

Ver. 1.1

Connection

Subwoofer*

Power amplifier*

Smartphone*

, iPhone*

USB device