32
GB
Installation
For Japanese cars, see “Mounting the unit in a
Japanese car” (page 32).
Mounting the unit with an installation kit
(not supplied)
Before installing, make sure the catches on both
sides of the bracket are bent inwards 3.5 mm (
5
/
32
in).
1
Position the bracket inside the
dashboard, then bend the claws outward
for a tight fit.
2
Mount the unit onto the bracket.
Note
If the catches are straight or bent outwards, the unit will
not be installed securely and may spring out.
Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
dealer.
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws
in
the appropriate screw holes based on your car:
T for TOYOTA, M for MITSUBISHI and N for NISSAN.
Note
To prevent a malfunction, install only with the supplied
screws
.
For details, see “Resetting the Unit” (page 7).
When replacing the fuse, be sure to
use one matching the amperage
rating stated on the original fuse. If
the fuse blows, check the power
connection and replace the fuse. If
the fuse blows again after
replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.
Mounting the unit in the dashboard
Catch
Bracket
Larger than
182 mm (7
1
/
4
in)
Larger than
111 mm (4
3
/
8
in)
Bracket
Resetting the unit
Fuse replacement
To the dashboard/center console
Parts supplied with
your car
Bracket
Bracket
Fuse (10 A)
