Sony Electronics Inc. • 16530 Via Esprillo • San Diego, CA 92127 • 1.800.222.7669 • www.sony.com
Last Updated: 01/18/2011
XM-ZZR3301
Class D, Mono Subwoofer Amplifier
Please visit the Dealer Source for current information at
www.sony.com/dealersource
Features
330W RMS (20Hz-200Hz 1.0% THD+N, at 4 Ohms, 14.4V)
1
This unit has a maximum output power of 600W per channel
at 4 Ohm.
600W RMS (50Hz 1.0% THD+N, at 2 Ohms, 14.4V)
This unit has a maximum output power of 1100W per
channel at 2 Ohm.
High Level Input with Sensing Power On
Direct connection
(High Level Input)can be made with the speaker output of your
car audio unit if it is not equipped with RCA line output.
High Level Sensing power on feature allows the unit to be
activated without the need for remote connection.
Variable 6-70Hz sub-sonic HPF (High Pass Filter) 12dB/Oct.
Subsonic Filter
Built in variable 12 dB/Oct LPF (Low Pass Filter)
from 50-300Hz enables users to concentrate the power on
lower frequencies.
Bass Boost
Variable 0-10 dB 40Hz bass boost provides
additional bass response at lower frequencies (rear channels
only).
Specifications
Audio Features
Level Control:
High Level Input: 6.0 - 16V
Audio
Frequency Response:
10-300kHz (+/-0dB)
Input Level:
0.3-6.0V (RCA pin jacks)
6.5-16.0V (High Level input)
Impedance:
2-8 Ohms
4-8 Ohms Mono
Noise Level:
65 dBA
Signal Circuitry:
6-70Hz Variable -12 dB/Octave Subsonic filter
Harmonic Distortion:
0.01% or less (50Hz)
Low Boost:
0-10dB (40Hz)
Circuit System:
Class D Technology
Pulse Power Supply
Power Supply:
Class D Technology
Pulse Power Supply
Band:
Low Pass Filter: 50-300Hz, -12dB/Oct
Amplifier Section
Power Ad Hoc:
330W at 4 Ohm from 20Hz-200Hz with < 1% THD
Speaker Impedance:
2-8 Ohm stereo
4-8 Ohms mono
Max power output:
1100W max power
Speaker
Impedance:
2-8 Ohms
Speaker Terminal Type:
Output
1
Power
Output Power:
Maximum Output: 600W (at 4 Ohms); 1100Wx1
(at 2 Ohms)
Current Drain:
At rated output: 60A (at 2 Ohms) Remote Input: 1
mA
Rated Output:
330W RMS (20 Hz - 200 Hz, 1.0% THD + N, at 4
Ohms, 14.4V)
600W RMS (100 Hz, 1.0% THD + N, at 2 Ohms, 14.4V)
Power Requirements:
12V DC Car Battery (Negative Ground)
Internal Power Supply:
Class D Technology
Pulse Power Supply
Input Voltage:
10.5-16V Power Supply Voltage
Inputs and Outputs
Input(s):
RCA Pin Jacks and High Level Speaker Input Connector
Line Level Input(s):
RCA pin jacks
RCA Audio Input(s):
Pin Jacks: 0.3 - 6V
Output(s):
Speaker Terminals
Audio In:
RCA Pin Jacks, High Level input connector
Audio Out:
Speaker Terminals
Dimensions
Weight:
Approx. 2.9kg (6lb 7oz) not included
Measurements:
14 1/8 x 2 1/4 x 11"
(357 x 55 x 277 mm)
Supplied Accessories
Mounting Screws (4)
High Level Input Cord
Protection Cap
Color:
Gray and Silver
UPC Code:
027242745131
1. CEA-2006 Compliant — Standardized “Voluntary” Testing & Measurement Methods for Mobile Audio
Amplifiers. This standard advocates a uniform method for determining an amplifier’s RMS power and signal-
to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total
Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to
20,000 Hz.
© 2009 Sony Electronics Inc. All rights reserved. Reproduction in whole or in part without written permission is
prohibited. Sony, Memory Stick, nav-u, Quick-BrowZer, Walkman, Xplod, ZAPPIN, and the Sony, nav-u and
Xplod logos are trademarks of Sony. iPhone and iPod are trademarks of Apple Inc., registered in the U.S. and
other countries. Bluetooth is a trademark of Bluetooth SIG, Inc. NAVTEQ Maps & Traffic is a trademark of
NAVTEQ. All other trademarks are trademarks of their respective owners. Features and specifications are
subject to change without notice. Non-metric weights and measures are approximate.
1
