Help Guide
print.html[3/31/2021 7:15:59 AM]
1
the
(Enter) button on the remote control.
You can switch to TV broadcasting by simply pressing the TV button on the remote control.
[10] Getting Started
Performing acoustic auto calibration
You can correct the audio to the best acoustics for your watching environment by using the remote
control microphone to measure a test sound from the TV. (This setting may not be available depending
on the model.)
Models that support acoustic auto calibration have the following setting.
[Settings] — [Display & Sound] — [Sound] — [Acoustic auto calibration]
Note
Calibration effects will vary depending on your watching environment.
A loud test sound will be played from the TV during measurement.
Do not block the microphone opening at the end of the remote control during measurement.
Do not move the remote control during measurement. Doing so may result in incorrect
measurement.
Perform the calibration when your surroundings are quiet. Noise may result in incorrect
measurement.
Acoustic auto calibration cannot be performed if you are using a sound bar. Change the
following setting.
[Settings] — [Display & Sound] — [Audio output] — [Speakers] — [TV speakers]
Press the
(Quick Settings) button on the remote control, then select the following
settings.
23
Summary of Contents for XR-83A90J
Page 149: ...Help Guide Troubleshooting 08 html 3 31 2021 7 16 09 AM 143 ...
Page 185: ...Help Guide Connecting terminal 01_10 html 3 31 2021 7 16 56 AM 179 ...
Page 285: ...Help Guide Playing content stored on a USB device 04 01_01 html 3 31 2021 7 19 28 AM 279 ...
Page 410: ...Help Guide Videos 04 01 03_03 html 3 31 2021 7 23 18 AM Copyright 2021 Sony Corporation 404 ...