Sony XR-H572A, Service Manual

THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS
AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)

• For printed wiring boards.

•

X

: parts extracted from the component side.

•

®

: Through hole.

•

¢

: internal component.

•

b

: Pattern from the side which enables seeing.

: Chip transistor of abbreviation (E, C, B)

• ((        )) : Page of service manual.

BCE

– 2 –

SECTION 1

DIAGRAMS

Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B)

pattern face are indicated.

Parts face side: Parts on the parts face side seen from the
(Side A)

parts face are indicated.

• For schematic diagrams.
• All capacitors are in µF unless otherwise noted.  pF: µµF

50 WV or less are not indicated except for electrolytics
and tantalums.

• All resistors are in 

Ω

 and 

1

/

4

W or less unless otherwise

specified.

•

%

: indicates tolerance.

•

¢

: internal component.

•

C

: panel designation.

•

U

: B+ Line.

•

H

: adjustment for repair.

• Power voltage is dc 14.4V and fed with regulated dc power

supply from ACC and BATT cords.

• Voltage is dc with respect to ground under no-signal

(detuned) condition.
no mark : FM
(

) :  AM

<

> : PB

∗

: Impossible to measure.

• Voltages are taken with a VOM (Input impedance 10 M

Ω

).

Voltage variations may be noted due to normal produc-
tion tolerances.

• Signal path.

F

: FM

f

: AM

E

: PB

• ((        )) : Page of service manual.

<<     >> : Page of supplement-1.

SUPPLEMENT-1

File this supplement with the service manual.

SERVICE MANUAL

Subject : Change of Main Board

When performing service and inspection, check the part number
of the main board.

(ECN-CSB00374)

XR-H572A/H572W/H572WT/

H573A/H573W

– MAIN  BOARD (SIDE A) –

Main board Part No.
Former :1-671-224-11
New

:1-674-279-11