9
INSTALLATION OF FLAT CABLE (L) 26P
Note:
Follow the assembly procedure in the numerical order given.
SECTION 3
ASSEMBLY
7
two screws
(M2
×
3)
6
FFC cover (2)
5
5
3
B board
4
four screws
(B2.6
×
4)
2
two flat cables (L) 26P
(CN705, 706)
4
screw
(B2.6
×
4)
B board
two flat cables (L) 26P
chassis (lower)
ass’y
Note: No slack is allowed.
filament tape 16
×
50
8
Using a filament tape 16
×
50,
stick two flat cables (L) 26P
to the chassis bottom without a slack
as shown in the figfure.
base ass’y
1
Pull the base ass’y
in the direction of arrow
A
.
A
0
Pull the flat cable (L) 26P in the direction of arrow
B
,
and stick it to the sheet (FFC) with an adhesive tape.
DC motor (small type) (slide) (M21)
B
adhesive tape
sheet (FFC)
qs
screw (M2
×
3)
qa
FFC cover (1)
0
Pull the flat cable (L) 26P
in the direction of arrow
C
,
and stick it to the sheet (FFC)
with an adhesive tape.
C
adhesive tape
sheet (FFC)
9
flat cable (L) 26P
(CN101)
9
Let the flat cable (L) 26P through
under DC motor (small type) (slide) (M21)
as shown in the figure, and connect to
the connector (CN102).
