18
4
Use the supplied squeegee
qj
to make sure the film
antenna is well attached to the window.
• Hold the antenna so it does not move while using the
squeegee.
• Work from the center of the antenna outward.
• Work the squeegee along the length of the antenna,
pushing out air bubbles to obtain a good seal.
• Do not rub the antenna too hard.
5
Use paper towels to wipe away the excess detergent
solution and dry the antenna well.
We recommend you let the antenna dry for 3-4 hours.
Do not try to rush the drying process by using a hair dryer
or other heater. Doing so may damage the film antenna.
4
Attach the power supply terminal to the film
antenna
qf
.
1
Remove the power supply point protective sheet from the
film antenna.
2
Attach the antenna input cable
qg
to the film antenna
power supply terminals.
• The same type of cable is used for both the left and right
antennas.
• Temporarily fastening the cable near the ground
connection with cellophane tape will make the
procedure easier.
Note
Make sure that the film antenna is
completely dry before continuing with
the mounting procedure. Continuing
before the antenna is dry may cause it to
come off the window.
The color of the protective sheet is used
to distinguish the left and right
antennas.
The right antenna (as seen from inside
the car) has a blue protective sheet, and
the left antenna has a white protective
sheet. Take care to mount the antennas
on the proper side of the car.
Connecting to the power supply
terminals
Align the protrusions on the power
supply terminals with the arrows
v
on
the film antenna and fasten in place.
Squeegee
qj
Protective sheet
Power supply point
Peel off the
protective sheet
Temporary fastening
(cellophane tape, etc.)
Power supply point
Peel off the
protective sheet
Temporary fastening
(cellophane tape, etc.)
Alignment marks
(protrusions)
Power supply
terminals
Alignment
marks (arrows
v
)
Summary of Contents for XTL-W7000
Page 34: ...12 拆卸機架 安裝本機之前 請拆卸本機的機架 1 將兩把解鎖鑰匙 qa 一起插入本機和機架 8 中直到聽 到喀嗒聲 2 拉下機架 8 然後向上拉本機使其分離 8 qa 將掛勾朝內 m ...
Page 46: ......
Page 47: ......
