19
3
Pass the antenna input cable
qg
through the roof lining
(inner roof panel).
5
Route the antenna input cable
qg
.
1
Apply the grounding tape
qh
to the car body.
Apply the grounding tape to the metal of the car body, in a
position where it can contact the ground contact on the
antenna input cable.
2
Affix the ground contact on the antenna input cable to the
grounding tape
qh
.
Peel off the protective sheet from the ground contact and
stick it completely to the grounding tape. Make sure that
no portion of the ground contact protrudes beyond the
grounding tape, and that there is no part of the ground
contact which is not firmly stuck to the grounding tape.
Notes
• Pull the roof lining down slightly and
thread the cable under it.
• Take care not to pull too hard on the
lining and bend it out of shape.
• Perform this step while holding on to
the power supply point to avoid
putting stress on that point.
• Route the antenna input cable carefully
to avoid pulling excessively on,
applying stress to, or kinking the cable.
Notes
• Carefully wipe away any dirt on the
attachment surface.
• Be sure to stick the grounding tape
completely to a flat, metal part of the
car body. Do not apply the grounding
tape to a place that is not flat, or over a
clip or screw hole. Do not scrape off
the finish on the car body.
roof lining
Grounding tape
qh
(peel off
the protective sheet)
Ground contact
(peel off the
protective sheet)
Summary of Contents for XTL-W7000
Page 34: ...12 拆卸機架 安裝本機之前 請拆卸本機的機架 1 將兩把解鎖鑰匙 qa 一起插入本機和機架 8 中直到聽 到喀嗒聲 2 拉下機架 8 然後向上拉本機使其分離 8 qa 將掛勾朝內 m ...
Page 46: ......
Page 47: ......
