8
`
/
1
V
/
v
INPUT
MODE
MENU
INPUT
ATT
`
/
1
VOL
VOLUME
＋/−
POWER
INPUT
Operation
Selecting the input source
You can select the input source.
1
Press
(POWER)
.
On the card remote commander, press
{
/
1
.
The power is turned on.
2
Press
(INPUT)
to select the desired input source.
Each time you press
(INPUT)
, the indication changes in the following sequence:
VIDEO 1
VIDEO 2
NAVI
RECEIVER
*
To select the connected navigation system
Press
(INPUT)
repeatedly to select “NAVI”.
Note
If you use the monitor with the rechargeable battery (MV-100BAT), the monitor
automatically enters into the receiver mode when turned on. The
(INPUT)
button is
deactivated and the input source is fixed to the receiver mode. See “Using the
rechargeable battery” (page 12).
*
Note on wireless transmission (Receiver mode)
Simultaneous use with other 2.4 GHz equipment may cause image interference or audio
noise. This is not a malfunction, but a result of equipment sharing the same operating
frequency.
