ZS-RS70BT/RS70BTB
22
Bluetooth INFORMATION INITIALIZE
Bluetooth information is initialized.
Procedure:
1. Press the [POWER] (Except AEP and UK models)/[OPER-
ATE] (AEP and UK models) button to turn the power on.
2. Press the [ PAIRING BLUETOOTH] button to select Blue-
tooth function.
3. Press and hold (about 2 seconds) the [ERASE] button.
4. The message “BT RESET” appears on the liquid crystal dis-
play.
5. Press the [ENTER] button, and the message “BT RESET” is
blink.
6. The message “COMPLETE” appears and initialization is per-
formed, and release from this mode.
Releasing method:
Press the [
x
] button, or do not perform operation for 10 seconds.
ERP TEST (AEP and UK models only)
The ERP audio signal detection check.
Con
fi
rm ERP test with reference to the following
fl
ow.
Procedure:
1. Press the [OPERATE] button to turn the power on.
2. Press three buttons of [AUDIO IN], [ /TUNE –] and [MODE]
simultaneously.
3. When an audio signal is inputted into IC801 (pin
rf
), “ERP H”
is displayed on the liquid crystal display.
When an audio signal is not inputted into IC801 (pin
rf
),
“ERP L” is displayed on a liquid crystal display.
ERP test
fl
ow:
Yes
Yes
No
No
Count reset of timeout
for 10 seconds
IC801 (pin
rf
I-AUDIO-IN-CHK)
is “L”
“ERP L” is displayed
State of “ERP L” is
10 seconds progress
Standby mode
“ERP H” is displayed
ERP test start
Releasing method:
Press three buttons of [AUDIO IN], [ /TUNE –] and [MODE]
simultaneously, or it will become standby mode if operation is not
performed for 10 seconds in the state of “ERP L”
Summary of Contents for ZS-RS70BT
Page 79: ...MEMO ZS RS70BT RS70BTB 79 ...
