ø3.5
16
2.3
ø6.3
22.2
1.0
ø8
ø4
United Kingdom and Worldwide Sales
Tel: +44 (0)8447 671131
Email: sales@sophos.com
North American Sales
Toll Free: 1-866-866-2802
Email: nasales@sophos.com
Australia and New Zealand Sales
Tel: +61 2 9409 9100
Email: sales@sophos.com.au
Asia Sales
Tel: +65 62244168
Email: salesasia@sophos.com
© Copyright 2018. Sophos Ltd. All rights reserved.
Sophos is the registered trademark of Sophos Ltd.
18-03-03 (2965-DD)
Rackmount Kit Mounting Instructions
SG 105(w)/115(w)
Rev. 3
Please note
This Rackmount kit can only be used with SG 105(w)/115(w) rev.3 models.
What is included in the box
6 flat head M3 screws
In addition to the rack mounting kit contents, you will need a long-handed Phillips-head screwdriver.
1. Remove existing screws from the chassis
Remove the three screws from each side of the
chassis.
2. Install the Rackmounting Kit Device Holder
to the Chassis
Please note
You can mount the unit either with the front or with
the back side facing to you (see figures below).
Secure one device holder to each side of the
appliance using three flat head M3 screws from the
scope of supply.
LEDs
Ports
1.
2a.
Front facing installation
2b.
Back facing installation
3b.
Wallmount installation
3a.
Rackmount installation
2 device holders (left, right)
The device holders must only be fixed to the
appliance by means of the supplied screws. Screws
with other dimensions might damage the appliance.
3. Install the unit
You can either install the unit into a rack (3a) or you
can hang the unit to a wall (3b).
Please use appropriate screws (not supplied with
this kit) for this purpose.
For wallmount installation we recommend using
wall plugs and screws with dimensions shown
below (3c).
3c.
