5
XGS 5500/6500
Operating Instructions
Technical Specifications
XGS 5500
XGS 6500
Physical Specification
#Fixed Ethernet Ports
16
20
#Fixed ByPass Port Pairs
2
2
max. #Flexi Ports
32
48
#Cores Main CPU
16/32
24/48
Main Memory
64GB DDR4 ECC 2666
80GB DDR4 ECC 2666
#Cores NPU
24
24
NPU Memory
12GB DDR4 ECC
12GB DDR4 ECC
Stoarge
2 x 480 GB HW RAID-1
2 x 480 GB HW RAID-1
Power Supply
1+1 Internal auto-ranging
100-240VAC, 50-60 Hz hot swap
1+1 Internal auto-ranging
100-240VAC, 50-60 Hz hot swap
Power Consumption (idle)
168.0W/573.81 BTU/h
188.00 W/642.13 BTU/h
Power Consumption (full load)
478.01W/1117.43 BTU/h
497.09 W/1697.8 BTU/h
Mounting
2U sliding rails (included)
min. rack depth: 588mm (23.125”)
max. rack depth: 870mm (34.25”)
2U sliding rails (included)
min. rack depth: 588mm (23.125”)
max. rack depth: 870mm (34.25”)
Dimensions
Width x Depth x Height
438 x 660 x 88 mm
17.24 x 25.98 x 3.46 inches
438 x 660 x 88 mm
17.24 x 25.98 x 3.46 inches
Weight (kg) unpacked/packed
17.8 kg/39.24 lbs (unpacked)
27 kg/59.53 lbs (packed)
17.8 kg/39.24 lbs (unpacked)
27 kg/59.53 lbs (packed)
Environmental
Noise level (avg.)
(Typical/Max Operation)
58.3/64.2 dBA
58.3/64.2 dBA
Operating Temperature
0°C to 40°C
0°C to 40°C
Storage Temperature
-20°C to 70°C
-20°C to 70°C
Operational/Storage Humidity
10% to 90% non-condensing
10% to 90% non-condensing
Operational/Storage Altitude
2000/5791 m
2000/5791 m
MTBF (hours)
(Telcordia SR-332 Issue 3)
135099
135099
Certifications (Safety, EMC)
CB, CE, UL, FCC, ISED, VCCI, CCC,
KC, BSMI, RCM, NOM, Anatel
CB, CE, UL, FCC, ISED, VCCI, CCC,
KC, BSMI, RCM, NOM, Anatel
LED Status
Status LEDs
Power 1
(Upper Power
Supply)
Green
Solid
Power Supply 1 Active.
Red
Solid
Power Supply 1 Failure.
Off
Power Supply not present
Power 2
(Lower Power
Supply)
Green
Solid
Power Supply 2 Active.
Red
Solid
Power Supply 2 Failure.
Off
Power Supply not present
SSD
Blue
Flashing
SSD reading/writing data.
BP 1/2
Green
Solid
Bypass mode on Ports 1/2 enabled.
Off
Bypass mode on Ports 1/2 disabled and inactive.
BP 3/4
Green
Solid
Bypass mode on Ports 3/4 enabled.
Off
Bypass mode on Ports 3/4 disabled and inactive.
LEDs on each RJ45 Ethernet connector
ACT/LNK
(Left LED)
Green
Solid
1. The Ethernet port has established link.
2. Good connection between the Ethernet port and hub.
Flashing
The adapter is sending or receiving network data.
Off
1. The adapter and switch are not receiving power.
2. No connection between both ends of network.
3. Network drivers have not been loaded
or do not function correctly.
Speed
(Right LED)
Amber
On
If Ethernet port is operating at 1000 Mbps.
Green
On
If Ethernet port is operating at 100 Mbps.
Off
If Ethernet port is operating at 10 Mbps.
