Sordin 75906 Series, Manual

9

INTRODUCTION

Sordin 75909 series are in conformity with the provisions set out in the RoHS directive 2011/65/EU. Thereby 

it fulfils the requirements for CE marking. Sordin 75909 is a waterproof dual com Product, which can 

immersion to a water depth of 1m 30min. The product is available for several different communication 

radios.
PTT button 1 (centre located)

PTT button (A) with pressure points that indicates the on/off position.
PTT button 2 (side located)

PTT button (G) with pressure points that indicates the on/off position.
Switch guard

The switch guard (B) is there to avoid involuntary pressing the PTT button.
Radio cable 1

The radio cable (C) with a contact for a specific communication radio or mobile phone.
Radio cable 2

The radio cable (H) with a contact for a specific communication radio or mobile phone.
Panel jack

The panel jack (D) is Sordin standard 6-pole female connector for Sordin headsets.
Cover Panel Jack 

The cover panel jack (E) is there to reduce the risk of getting water and dirt into the pane jack when no 

headset is connected.
Belt clip

The belt clip (F) can be used to attach the PTT box to a belt or to other fastening system such as MOLLE 

system (Modular Lightweight Load-carrying Equipment). The belt clip can rotate 360˚.

If you instead want to place the PTT box in a pocket intended for PTT box, it is possible to remove the belt 

clip by loosening the four fixing screws. 

INSTRUCTIONS FOR USE

•  Connect the headset to the PTT box and the PTT box to two communication radios or mobile phones.

•  Switch the communication radios on and adjust the volume to the desired level.

•  Keep the PTT buttons pressed while transmitting and release the PTT button to receive, if you connect 

the PTT box to a communication radio.

•  Push the PTT buttons shortly to answer or hang up if you connect the PTT box to a mobile phone.

•  If you press the centre located PTT button (A) start transmitting on radio cable (C).

•  If you press the side located PTT button (G) start transmitting on radio cable (H).

•  Incoming radio signal from radio cable (C) will be heard in the right cup.

•  Incoming radio signal from radio cable (H) will be heard in the left cup.

Cleaning

•  Assemble the cover for the Panel Jack.

•  Protect the radio connectors from water.

•  Use a soft brush or sponge moistened with a solution of water and dishwashing detergent or similar.

•  Rinse the equipment and leave it to dry.

NOTE! Never use a solvent for cleaning.
Spare parts

•  Belt clip SW044

•  Cover Panel Jack JD007

Use and storage:

Temperature range for use: -20˚C to +50˚C

Recommended storage conditions: -20˚C to +50˚C, <85% humidity

Recommended maximum shelf life: 5 years

Sordin 75909 Series (Waterproof Dual Com)

DESCRIPTION

GB