20
E.2 Parametrisation
E.3 Free commissioning
If you decide not to use the commissioning help, you should make the
necessary settings in the following sequence:
- Menu 10.
Language
- Menu 7.3
Time and date
- Menu 7.1
Program selection
- Menu 5.
Settings, all values
- Menu 6.
Protective functions if adaptations are necessary
- Menu 7.
Special functions if additional changes are necessary
Finally, menu 4.2 under operating mode “Manual“ should be used to test the switch
outputs with the consumers connected, and to check the sensor values for plausibility.
Then switch on automatic mode.
vides brief descriptions of each parameter in the display. Pressing the “esc” key takes
you back to the previous value so you can look at the selected setting again or adjust
it if desired. Pressing the “esc“ more than once takes you back step by step to the
selection mode, thus cancelling the commissioning help. Finally, under operating mode
menu 4.2 “Manual” should be used to test the switch outputs with the consumers
connected, and to check the sensor values for plausibility. Then switch on automatic
mode.
The fi rst time the controller is turned on
and after the language and time are set,
a query appears as to whether you want
to parametrise the controller using the
commissioning help or not. The commis-
sioning help can also be terminated or
called up again at any time in the special
functions menu. The commissioning help
guides you through the necessary basic
settings in the correct order, and pro-
Operation
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary
for your application.
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary
for your application.
