Sorensen MML Series Operation and Programming Manual
4-16
4.2.9 Saving Defaults
Press SAVE, and the
▼
key until the display shows as follows. The DEFAULT states
are used for electronic Load after power-on. Press 1 to save DEFAULT to EEPROM.
SAVE DEFAULT
1:YES
2:NO
4.2.10 Saving Programs
Press SAVE, and the
▼
key until the display shows as follows. Press 1 to save
program.
SAVE PROGRAM
1:YES
2:NO
4.2.11 Going To Local
The SHIFT key operates as a local key, LCL when electronic Load is in remote mode.
You can press the LCL key to go to local operation when Load is in remote state. In
local operation, SHIFT operates as the shift key.
4.2.12 Lock Operation
The lock operation disables any setting for change. When data are locked, no settings
can change. The operation of ON/OFF and SPEC keys will not be affected by lock
function. Press SHIFT and “.” simultaneously to enable/disable lock function. This is
a toggle key to enable/disable lock function.
4.2.13 Setting System and RS-232C Connection
The parameters of RS-232C are set in the system. There are three parameters for
you to set:: Baud Rate, Parity Check, and Data Bit number. Press SHIFT and 0
simultaneously to set system data.
Baud Rate : 0:600, 1:1200, 2:2400, 3:4800, 4:9600 bits/second.
Parity Check : 0:EVEN, 1:ODD, 2:NONE.
Data Bit
: 0:7 bits, 1:8 bits.
The RS-232C connector on the rear panel of Mainframe is a 9-pin connector (DB-9,
male connector). The RS-232C connector bus signal is defined as follows.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
