26 von 36
service record Airon
2021-06-10
3.8.3 Adjust the back angle roughly
3.8
Back assembly
(1+2)
To roughly adjust the angle of inclination of the backrest, remove the screw connection
(A)
, loosen the screws
(B)
, tilt the back tubes into the desired position, then insert the screws
(A)
in the new position and tighten them all again. The angle setting must be identical on the
right and left. The rough back angle adjustment is made in 12 ° steps.
(1)
(A)
(B)
(A)
(B)
(2)
3.8.4 Fine adjustment of the back angle
When the Airon is delivered, you have selected
a level of activity when you placed your order.
Depending on the level of activity, either the
0 ° insert
(3A)
or the 4 ° insert
(3B)
is inserted
in the recess
(6C)
. With the help of these discs
you can fine-tune the back angle in 4 ° steps. To
do this, insert either 0 ° insert
(3A)
or 4 ° insert
(3B)
into the recess
(6C)
. If the insert 0 ° is in-
serted, the angles 78 ° / 90 ° / 102 ° / 114 ° can
be set as described in chapter 3.8.3.
If the insert-4 ° is inserted with the hole facing
up, the angles 82 ° / 94 ° / 106 ° / 118 ° can be
set as described in chapter 3.8.3.
If the insert-4 ° is inserted with the hole facing
down, the angles 74 ° / 86 ° / 98 ° / 110 ° can be
set as described in chapter 3.8.3. You can adjust
your back angle in 4 ° steps between 74 ° and
118 °.
The uninserted insert can be found screwed
tight on the inside of the frame
(4 A)
To exchange the insert, first remove the screw
(5A)
and take the insert out of the recess
(9C)
.
Now insert the enclosed insert and tighten the
screws again. Make sure that you set the inserts
equally on both sides.
(3)
(4)
(A)
(5)
(A)
(6)
(C)
(A)
(B)
(2)
0°
-4°
2x
2x
2x
2x
2x
2x
