12 of 28
Service Record Boogie Fix and Swing
2019-08-12
3.4 Assembly Group Knee truss pad
3.4.1 Standard knee truss pad
The pads can optionally be equipped with set screws or clamping levers.
In the following chapters, the setting process is described based on the picture used. If your
standing aid is equipped differently, please proceed accordingly.
Before the first use of the standing aid, the knee truss pad must have been adjusted as far
as possible to the individual measurements of the child / adolescent. If the user stands in the
standing aid, only fine adjustments may be made.
We recommend adjusting the width of the knee pads to the user's level before the first use.
(1)
Loosen the clamp levers
(C)
on both sides and remove the knee truss pads.
(1)
To adjust the knee truss pad size 1:
• Loosen the two screws
(A)
,
• telescope the two holders
(B)
on the
oblong holes to the desired dimension
• and tighten the screws
(A)
again.
(2)
To adjust the knee truss pad size 2:
• Loosen the four screws
(A)
,
• telescope the two holders
(B)
to the
desired size
• and tighten all screws
(A)
again.
(3)
To adjust the height:
• Loosen the screw
(A)
,
• move the crossbar
(B)
to the desired
height and
• retighten the screw
(A)
.
(1)
and / or:
• Loosen the clamping levers
(C)
on both
sides,
• turn the holder
(D)
180 ° and
• retighten the clamping levers
(C)
.
(1)
and / or:
• Loosen the clamping levers
(C)
on both
sides,
• remove the knee truss pad,
• turn the holder
(E)
vertically by 180 °,
• put it back on the traverse
(F)
and
• retighten the clamping lever
(C)
.
(1)
(2)
(A)
(A)
(B)
(B)
(3)
(A)
(C)
(D)
(E)
(F)
(B)
