www.sotm-audio.com
sPS-1000 Front Panel
1.
DC power output ON/OFF switch
It is used to turn on/ off the DC power output.
CAUTION: Make sure that the output voltage setting knob on the rear panel and the cable connections should be correct before you turn on
the DC power switch, otherwise they will damage the unit.
2.
Operating status lamp
It is used to indicate the operational status. When you turn on the switch, the lamp is on, and when you turn off the switch, the lamp is off.
If there is abnormal situation such as over current or short, the lamp will blink repeatedly.
In this case, the power switch on the rear panel should be off and then turn on the power again after you remove the cause.
sPS-1000 Rear Panel
1.
OUTPUT 1
This jack is for DC power out, it can be connected with the audio device which needs around 18V-21V. e.g.) music server as like sMS-1000, PC, turntable.
The jack size is OD 5.5mm, ID 2.0mm.
2.
SETTING 1
This knob is to change the output voltage of OUTPUT 1. Please rotate the knob with a small flat-head screwdriver and set to the proper output voltage.
The output voltages by the switch knob positions are 1 : 18V, 2 : 19V, 3 : 20V, 4 : 21V
CAUTION: Make sure that turn off the switch on the rear panel when you set the output voltage.
3.
OUTPUT 2
This jack is for DC power out, it can be connected with the audio device which needs around 9V-12V. e.g.)DAC as like sDP-1000, small music player, NAS
The jack size is OD 5.5mm, ID 2.5mm.
4.
SETTING 2
This knob is to change the output voltage of OUTPUT 2. Please rotate the knob with a small flat-head screwdriver and set to the proper output voltage.
The output voltages by the switch knob positions are 1 : 9V, 2 : 10V, 3 : 11V, 4 : 12V
CAUTION: Make sure that turn off the switch on the rear panel when you set the output voltage.
5.
OUTPUT 3
This jack is for DC power out, it can be connected with the audio device which needs 5V-7V. e.g.) small audio devices such as tX-USBexp, dX-USB HD, or network router
The jack size is OD 3.5mm, ID 1.3mm.
6.
SETTING 3
This knob is to change the output voltage of OUTPUT 3. Please rotate the knob with a small flat-head screwdriver and set to the proper output voltage.
The output voltages by the switch knob positions are 1 : 5V, 2 : 5.5V, 3 : 6V, 4 : 7V
CAUTION: Make sure that turn off the switch on the rear panel when you set the output voltage.
7.
AC INPUT
This is IEC INLET connector, please check the input AC voltage before you make a connection.,
8.
ON/OFF switch
This is AC power on/off switch.
Please make sure that turn off the switch when you don’t use this unit or when you set the output voltage.
9.
Earth terminal
This is to connect to the earth(ground).
1
2
3
4
5
6
2
8
7
9
1
