Sound Choice Pro Audio
www.scpaudio.com
1002M -Pre-Amplifier page 7
FUNCTIONS (Rear Panel)
8. ~ 240V 50Hz AC POWER
Be sure to check correct AC voltage.
IMPORTANT NOTICE: Be sure not to make a
shorten for battery and polarity of battery.
9. DC POWER
Connection point of 24V DC power
10. OUTPUTS 1,2
Balanced XLR Output sockets. These Outputs
can be selected by switches on each of the Input
Channels on the front panel.
11. RECORDING
A pair of unbalanced RCA sockets are provided
for connecting a recording device. The mono
signal is converted to stereo in the internal
circuitry. Recording output volume can not be
adjusted by the Master volume controller as the
the signal is taken before the Master control.
12. LINE 7-10 INPUTS
A pair of unbalanced RCA sockets are provided
for connecting other audio replay devices (CD,
DVD, MP3, Tuner, etc). [10dB(245mV) input
level] The input circuitry converts the signal into
mono.
13. MIC/LINE 2-6 INPUTS
MIC/LINE balanced input can be selected by a
mode switch in the front panel.
IMPORTANT NOTICE:
Please ensure the volume is turned right down
before connecting a cable.
14. P.T.T. 1
Connect this terminal with MIC priority and
chime controls are activated from MIC (P.T.T
remote).
The microphone cable with shield can be
extended up to 30m.
IMPORTANT NOTICE:
Be sure not to make a short to the ground as the
microphone , is for operating power of
the condensor microphone.
15. CHIME REMOTE TERMINAL
This is a terminal for chime signal.
