- 23 -
A10-TX User Guide
Certifications
Industry Canada Conformity
EN: This device complies with Industry Canada RSS-210. Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
FR :Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio RSS-210. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne
doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
FCC Conformity
The A10-TX transmitter complies with the following requirements:
FCC (Federal Communications Commission) Part 74
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modification not expressly approved.
A10-TX frequency ranges supplied for use in USA:
• 470.2–547.8 MHz
• 518.2–607.4 MHz
ª
Frequency range 608–614 MHz is forbidden for use in US.
ª
Warning! Any modifications or changes made to this device, unless explicitly approved by
Audio Ltd. may invalidate the authorisation of this device. Operation of an unauthorised
device is prohibited under Section 302 of the Communications act of 1934, as amended,
and Subpart 1 of Part 2 of Chapter 47 of the Code of Federal Regulations.
Output power is conducted average. This device is certified for portable use.
Declaration of Conformity
The Declaration of Conformity documentation is provide online at:
https://www.sounddevices.com/audio-ltd-doc/
.
Before putting the products into operation, please observe the respective country-specific
regulations.
Minimize RF Exposure
To avoid the possibility of exceeding the FCC RF exposure limits, body-worn operations are
restricted to belt-clips, holsters or similar accessories that have no metallic component in the
assembly and which provide at least 7mm separations between the device and the user’s body.
