Sound Devices MixPre-10M User Manual Download

Page: 74 / 75

User’s Guide

Limited Warranty
No  warranties.  Sound  Devices,  LLC  expressly  disclaims  any  warranty  for  the  SOFTWARE
PRODUCT. The SOFTWARE PRODUCT and any related documentation is provided “as is” without
warranty or condition of any kind, either express or implied, including, without limitation, the
implied  warranties  and  conditions  of  merchantability,  fitness  for  a  particular  purpose,  or
non-infringement. The entire risk arising out of use or performance of the SOFTWARE PRODUCT
remains with you. No liability for damages. In no event shall Sound Devices, LLC or its suppliers
be  liable  for  any  damages  whatsoever  (including,  without  limitation,  damages  for  loss  of
business profits,  business interruption, loss  of  business information,  or  any other  pecuniary
loss) arising out of the use of or inability to use this Sound Devices, LLC product, even if Sound
Devices, LLC has been advised of the possibility of such damages. In any case, Sound Devices,
LLC’s entire liability under any provision of this evaluation license shall be limited to the greater
of the amount actually paid by you for the SOFTWARE PRODUCT or U.S. $5.00. Because some
states/jurisdictions  do  not  allow  the  exclusion  or  limitation  of  liability  for  consequential  or
incidental damages, the above limitation may not apply to you.

Governing Law
This agreement and limited warranty are governed by the laws of the state of Wisconsin.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. FCC Part
15.19 (a) (3)

Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can  radiate  radio  frequency  energy  and,  if  not  installed  and  used  in  accordance  with  the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:



Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.



Consult the dealer or an experienced radio/TV technician for help.

This device complies with FCC and ISED RF Exposure SAR limits exposure limits for general
population / uncontrolled exposure.

This Device complies with Industry Canada License-exempt RSS standard(s). Operation is
subject to the following two conditions: 1) this device may not cause interference, and 2) this
device must accept any interference, including interference that may cause undesired operation
of the device.