12
4) Playing the jukebox
Making Selections
When the discs and labels are installed, selections can be made using the keyboard at the
front of the jukebox or via the remote control.
To “flip” the title rack pages press the red button located underneath the number “9” on
the button bank.
To play a track, select the 3 digit number for the disc, and then the 2 digit number of the
individual track. These numbers will show up on the display as they are entered.
To play the whole of an album, without keying all the tracks individualy, select the 3 digit
disc number then enter the 2 digit track number as ‘00’.
To eject an entire disc press ‘EJECT DISC’ on the infra red remote.
To reject a single track press ‘EJECT TRACK’ on the infra red remote.
If you make a mistake while entering a selection press ‘KYBRD CANCEL’ on the infra red
remote to re-start the selection process, or press “C” on the jukebox button bank.
For continuous random play, press ‘SHUFFLE ON’ on the remote, the display will briefly
show ‘SH On’ and a small dot will appear in the bottom right corner of the LED display.
To turn off this function, press ‘SHUFFLE OFF’, the display will briefly show ‘SH OFF’ and
the dot in the bottom right corner will clear.
Please note: If the door is opened while the jukebox is playing, the CD will reject and the
CD mechanism will return to its central position.
Adjusting Volume
As a precaution against overloading the speakers when switching the jukebox on, the
volume is preset to a low level. To raise the volume to the preferred level, select a track,
wait until the CD is playing, then adjust the volume using the ‘Channel 1/2’ volume keys
on the remote control unit (See fig 7 opposite for remote control layout - the volume
adjustment buttons are shown highlighted in blue).
The display will briefly show the volume level as ‘L -’. The number will vary dependant on
the volume level with 0 for off and 50 for full volume.
The ‘Channel 3/4’ volume keys (on the remote) are used to adjust the volume of the
spare amplifier channels, please refer to section 6 “Adding additional speakers”.
Pressing the ‘MUTE’ key on the remote, will instantly mute the amplifier and the display
will show ‘L —‘, to return the volume to the previous level press any of the volume keys.
