9
How to locate and remove retaining bolt wingnuts
When in transit mode the Jukebox player mechanism will be locked into
position by 6 wing nuts that are located under the mechanism shelf. These must
be loosened before initial operation. The loosening of the wingnuts allow the
mechanism to float freely and dampen any vibrations which may effect the vinyl
playback. These wingnuts are easily removed however, 3 of the wingnuts are
located behind the bass speakers so these need to be removed to gain access to
the wingnuts.
How to locate and remove retaining bolt
wingnuts
• Locate the 3 wingnuts on the front of the lower shelf
as shown in Fig3. Simply losen these wingnuts by
hand and remove them. All transit parts including the
wingnuts should be kept safe for fututre use.
• Locate and undo the clip retaining the wires
underneath the shelf.
• Unplug the speaker connectors from their sockets.
• Locate the bass speaker box retaining screws.(Fig3)
Then remove these screws.
• The speaker boxes can now be slid forward and
removed temporally to gain access to the rear
mechanism retaining wingnuts.
• Remove the rear mechanism retaining wingnuts.
• As the wingnuts are removed the mechanism will lift
allowing access to the thin pieces of wood underneath
the mechanism. These are in place to help clamp the
mechanism down to the shelf when in transit mode.
• Slide out the thin pieces of wood from underneath the
mechanism.
• The speaker boxes can now be re-fitted and connected
back to the amplifier via their plug sockets.
• PLEASE ensure the speaker boxes are connectd
properly and that they are secured firmly back in place
prior to operating the jukebox.
The transit pieces can now be removed from the rest of the jukebox.
Summary of Contents for SL33
Page 1: ...SL33 Vinyl Jukebox User Manual Series 3 Unity Build 7 0 ...
Page 33: ...33 ...
Page 34: ...34 ...
Page 35: ...35 ...
