This fuse location will protect the system and the vehicle against the possibility of a short circuit in the power cable.
Be sure to use fuses and fuse holders adequate for the application.
GND ( GROUND CONNECTION )
Locate a secure grounding connection as close to amplifier as possible.
Make sure the location is clean and provides a direct electrical connection to the frame of the vehicle.
Connect one end of a short piece of the same size cable as the power cable to the grounding point.
Run the one end of the cable to the grounding point. Run the other end of the cable to the mounting
location. Connect the ground cable to the screw terminal labeled as GND.
REM ( REMOTE CONNECTION )
Run a remote turn on cable from the sw 12V source. You will be using to turn on the system components.
This may be a toggle switch, a relay, or your source unit's remote trigger cables, or power antenna trigger cable
Connect the remote turn on cable to the power terminal labeled as REM.
*.
Installation
In case, You install SoundQubed amplifiers by yourself, please read owner's manual and follow your
installation steps very carefully. Before you start your installation,
Please take all steps into consideration.
or, you can have SoundQubed authorized distritutors to check installation and set your car audio systems
*.
Mounting preparation
Disconnect the negative ( ) battery cable before mounting SoundQubed amplifiers or making any connections.
Check the battery and alternator ground ( ) connections.
Make sure they are properly connected and free of corrosion before selecting a mounting location for SoundQubed
amplifiers
Please take some concerns into consideration with cooling efficiency and safety.
*.
Mounting location
SoundQubed amplifiers use heavy-duty and good heat radiation heatsink design for avoiding excessive heat from
SoundQubed amplifiers’ circuitry.
But for better heat radiation performance, it is good to find the mounting location where you can install
SoundQubed amplifiers vertically with the heatsink fins and better air flow around SoundQubed amplifiers.
For the safety, You have to find dry and well ventilated location and make sure any cables and car equipment are not
interfaced with mounting location.
Be sure the mounting location and drilling of pilot cables for mounting will not present a hazard to any cables, control
cables, fuel lines, Fuel tanks, hydraulic lines or other vehicle systems or components
INSTALLATION
