7
PowerSwap. You can have a single switch toggle the unit or separate switches to go to either an on or off state. If your foot pedal
has additional switches that send out two value Controller commands, sometimes referred to as “Instant Access” switches, you
may use one of these switches as well to control the PowerSwap. Refer to the charts in the next sections to determine which
Program Change commands or Controller numbers to use for your setup.
Refer to the chart to determine which Program change or Controller you should use.
Program number if using Program Change commands
Function
Program (0-127 range)
Toggle between speaker A or speaker B using a single switch
0
Connect amp to the speaker A
1
Connect amp to the speaker B
2
Controller number if using Control Change commands
Function
Controller Number
Toggle between speaker A and speaker B (0=speaker A 127=speaker B)
0
