www.soundskulptor.com
Document revision 1.3 – Last modification : 09/10/14
Switcher-2 Assembly guide – Shield
6. Switcher-Shield assembly
Warning
: This must be done after the switcher has been fully tested in the
MC624.
Insert the switcher PCB into the shield, making sure the pins position
follows the shield top writing.
Check that the PCB is horizontal and solder the connecting pad on the
side.
7. Closing the shield
Place the closing side over the switcher PCB. Check that it is
horizontal and regularly recessed then solder the pads.
Copyright ©2013 to Today SoundSkulptor
