5
9. High Current Filter(Switched) Outlets:
These
outlets have a special filter circuit designed to
handle high current components like power
amplifiers or Active Speakers
10. Gold-Plated Ground Post:
Provides a
connection point for any ungrounded
components.
11. Thermal Circuit Breaker:
Protects the
PMX-6600 from power overload.
12. Breaker Open:
When this LED is on the
thermal circuit breaker has tripped due to an
overload. Before resetting the breaker, find
the reason for the overload.
13. Ultra-High Current AC Power Cable:
Integral
high power, heavy duty AC cable to maximize
power transfer to high current components
such as amplifiers.
REMOTE Mode:
These require a 12 volt triggering
device such as that typically found in most power
receivers and audio pre-amp processors
WARNING:
If the “BYPASS" switch is not engaged,
All “Switched" outlets will not supply power until a
12V trigger is present!
16. Voltage Meter:
Three-character LED displays the
line voltage at the source.
18. Unswitched Convenience Outlets:
These are
"always on” filtered power outlets
19. USB Charger:
Two 5V/1A convenience chargers
for portable electronic devices.
Note:
For best performance were commend plugging
analog components into the analog outlets and
digital to digital. It will not harmony components if
they are plugged into any other outlet
14.
Bypass/Remote
Switch:
The
PMX-6600
has
two
power-on/off
modes,
one
is
through
the
Power
On/Off
Switch
on
the
front
panel,
and
the
other
one
is
through
the
external
12V
trigger.
(Once
the
PMX-6600
is
powered
on
by
“REMOTE”
mode,
then
the
Power
On
/Off
Switch
on
the
front
panel
will
not
functional)
BYPASS
Mode:
For
those
who
do
not
wish
to
utilize
the
12V
triggering,
a
convenient
bypass
switch
is
located
adjacent
to
the
input
and
output
jacks.
By
switch
to
the
“BYPASS"
position,
the
2
x
USB
Chargers
and
12
x
Rear
Panel
Mounted
Outlets
(3
Zones)
will
be
operated
when
the
front
panel
power
on/off
switch
is
engaged.
15.
Remote
Turn
On/Off:
3.5mm
(1/8”)
mono
mini-plug.
Connect
to
a
remote
trigger
device
that
used
a
DC
output
to
trigger
is
startup/shutdown
sequence.
DC
IN
2~30V
(Trigger
In):
Allows
source
components
to
control
and
turn
on
the
switched
outlets
into
operation
of
PMX-6600
DC
OUT
12V
(Trigger
Out):
Provides
12V
signal
to
control
source
equipment
or
another
PMX-6600
device
for
sequencing
of
equipment.
17.
Amperage
Meter:
Three-character
LED
displays
the
amperage
usedbyequipmentpluggedinto-
the
PMX-6600.
