It is possible to play two Outcast Juniors from one transmitter. They can be configured in two
ways:
1. Each unit is an individual stereo unit playing both left and right on each unit
2. Each unit is set as part of a stereo pair (left or right)
Note: This feature is only available when using a wireless transmitter. You can not use this
feature when playing from the auxiliary input connector.
Each unit as an individual stereo unit
To play both Outcast Juniors together, each as individual stereo units, just select the same
channel on both Outcast Juniors. Follow the same steps as in the Wireless Playback from a
Soundcast Transmitter section.
Each unit as part of a stereo pair
To play the two Outcast Juniors as a stereo pair configure as follows:
Set each unit to the same channel as the transmitter. Follow the same steps as in the Wireless
Playback from a Soundcast Transmitter section.
Setting up 2 Outcast Juniors to play from one transmitter
Track back
Track forward
Play / Pause
Power on / off
Power on / off
Power on / off
Volume up
Volume up
Volume up
Note: Configuration change mode will only be active for 15 seconds after turning the unit on. After 15 seconds you will
need to turn the unit off and then on again to re-enter the configuration change mode. Once the unit has been changed
to left, right, or stereo, the unit will remember the last setting when it is powered off. So you do not have to repeat any
steps unless you want to change the configuration to something different than the last setting.
To configure a unit to be a left speaker, press the power button to power the unit on, once the blue link light
comes on, immediately press and hold down the “+”, the “-”, and “track back” buttons. The light will illuminate
green. You can now release both buttons. The unit is now configured as a left channel only speaker.
To configure a unit to be a right speaker, press the power button to power the unit on, once the blue link light
comes on, immediately press and hold down the “+”, the “-”, and “track forward” buttons. The light will illuminate
green. You can now release both buttons. The unit is now configured as a right channel only speaker.
To configure a unit back to a stereo unit, press the power button to power the unit on, once the blue link light
comes on, immediately press and hold down the “+”, the “-”, and “play / pause” buttons. The light will illuminate
green. You can now release both buttons. The unit is now configured as a stereo speaker.
Volume down
Volume down
Volume down
9
