CONNECTORS
The booster/splitter is using cage clamp terminals for both, input and output. This type of connector is very
reliable, ruggedized and easy to use. Use a flat blade screwdriver only. To open, press lever, insert cable
and release. For stranded wires, we suggest to use (insulated) ferrules.
The DMX data outputs are optically isolated in respect to to the DMX signal input.
DMX INPUT
Signal input for control signals according to USITT DMX512/1990 or DIN 56930-2
Pin 1
grey
screen / GND
Pin 2
blue
DMX - (inverted)
Pin 3
orange
DMX + (normal)
DMX OUTPUTS
6 outputs, galvanically isolated from the DMX signal input
Pin 1
grey
OUT 1 screen / GND
Pin 2
blue
OUT 1 DMX - (inverted)
Pin 3
orange
OUT 1 DMX + (normal)
Pin 4
grey
OUT 2 screen / GND
Pin 5
blue
OUT 2 DMX - (inverted)
Pin 6
orange
OUT 2 DMX + (normal)
POWER SUPPLY
24VDC approx. 100mA
Pin 1
blue
0.0V
Pin 2
red
24.0V DC
POWER SUPPLY
The power supply is 24VDC. Make sure a stable and regulated DC power source is being used.
Electrical voltage can be dangerous to your health; connections must be carried out by a qualified
technician only.
Make sure the unit has been disconnected from mains before making any other connections to the
booster/splitter. Verify installation before re-applying power.
SIGNAL INDICATORS
Signalling is provided for user guidance.
The state of the booster/splitter interface is signalled by 2 LED indicators.
Color
Labelling Description
green
SIGNAL Valid DMX signal detected
green
POWER Power supply present
DMX IN
DMX / DMX RDM con-
trol signal input
DMX OUTPUTS
2 comman optically iso-
lated outputs in respect
to DMX IN
POWER SUPPLY
24V DC approx. 3W
