TECHNICAL DATA
Dimensions
134mm (W) x 67mm (H) x 92 mm (D)
Supply:
24V DC approx. 100mA
DMX IN:
1 Unit Load
DMX OUT:
2 outputs, buffered, optically isolated vs input
DMX Protocol:
USITT DMX512/1990, DIN56930-2, ANSI E1-11 DMX512-A, ANSI E1-20 DMX RDM
RDM device:
Transparent Device, no UID
Display:
2 LED indicators
Operating Temp: 0C...+50C
Weight:
72 g
Mounting:
on 35mm DIN rail, width 2 units
IP rating:
IP20, for dry rooms only
Order No.:
3402B-H
DMX RDM PROPERTIES
The 3402B-H can process DMX512, DMX512-A and/or DMX RDM telegrams. In respect to RDM traffic, the
3402B-H acts as "invisible" device, which cannot be discovered or addressed. Please refer to the 3402B-H
product page (see below) for more information regarding RDM properties.
CE CONFORMITY
This DMX splitter/booster is microprocessor controlled and uses high frequency (16 MHz
quartz). The interface has been tested in the EMC lab to comply with EN55015.
To ensure the best performance regarding radiated and conducted emissions please make
sure that shielded data cable is used and the shield is connected properly to the GND pin.
Shield must never make contact to other signal lines.
DISTURBANCES
If a trouble-free operation cannot be guaranteed, disconnect the booster/splitter and secure it against unwan-
ted operation. This is especially necessary, when
- the unit has visible damages;
- the unit does not operate;
- internal parts are loose;
- connection cables show visible damages.
LIMITED WARRANTY
This instrument ist warranted against defects in metarials and workmanship for a period of 24 month, begin-
ning with the date of purchase. The warranty is limited to repair or exchange of the hardware product; no fur-
ther liability is assumed. SOUNDLIGHT is not responsible for damages or for loss of data, sales or profit
which arise from usage or breakdown of the hardware product. In Germany, SOUNDLIGHT will repair or re-
place established defects in hardware, provided that the defective part is sent in, freight paid, through the
responsible dealer along with warranty card and/or sales receipt prior to expiration of warranty.
Warranty is void:
- when modifying or trying to repair the unit without authorisation;
- modification of the circuitry;
- damages by interference of other persons;
- operation which is not in arccordance with the manual;
- connection to wrong voltage or current;
- misuse.
