To turn on the system ‘on’, press the POWER button at back side of the unit and
set the volume to a low level, the tuning dial light comes ‘on’.
Press the function buttons(UKW/MW) for desired band, UKW or MW.
Rotate the TUNING control to the desired radio station.
Ajust the VOLUME control as desired.
When you have finished listening, press the ON/OFF button again. The tuning dial
light goes ‘off’.
UKW - The UKW antenna is the rod at the top of the cabinet. If UKW reception is
unsatisfactory, try adjusting the rod at any direction till the reception is good.
MW - The MW bar antenna is inside the cabinet. If MW reception is unsatisfactory try
repositioning the cabinet slightly until the internal antenna is picking up the strongest
signal.
4
Battery Operation
The unit can be operated by DC, you may put 6pcs batteries(UM-2 “C” R14 2# DC1.5V,
not include.) into the battery compartment on the bottom of the cabinet. The function is
the same as that of AC power
Battery Compartment
Headphone
This unit will accept headphones(not included) with a 3.5mm plug. The speaker is
automatically disconnected when headphones are connected to the PHONES jack.
NOTE: Excessive sound pressure from earphones and headphones can cause
hearing loss. Listening to music at high volume levels and for extended durations can
damage one’s hearing. In order to reduce the risk of damage to hearing, one should
lower the volume to a safe, comfortable level, and reduce the amount of time listening
at high levels. Headsets should comply with EN 50332-2 requirements
