8
POWER SUPPLY
1.
BATTERY OPERATION
-
Remove the battery compartment door.
-
Insert 6 pieces UM-1 (D size) batteries into the battery compartment with battery polarity
positioned as indicated. Note: we recommend the use of alkaline batteries.
-
Close the battery compartment door.
2.
AC OPERATION
-
The AC power cord is located inside the battery compartment.
-
Plug the AC line cord into any normal household AC mains outlet in correct voltage and the mains
socket.
RADIO OPERATION
Set the FUNCTION SWITCH to “RADIO” position.
FM/FM ST. BAND
Select FM ST. mode by band selector switch. Turn the TUNING control to select the desired station. The
FM stereo indicator will light up which shows a FM stereo broadcast is being received. Fully extend the
antenna rod and adjust its direction for best FM reception. If the FM broadcast signal is weak, slide the
switch to “FM” position to turn off the FM stereo, FM stereo indicator will disappear and the
background noise will be reduced but the broadcast becomes monoaural.
AM BAND
Select AM mode by band selector switch. Turn the TUNING control to select the desired station. For
AM reception, the set is controlled by a built-in ferrite aerial which is directional. Therefore, the set
should be positioned for the best signal strength.
CASSETTE OPERATION
PLAYBACK OF CASSETTE
Be sure to tighten any slack tape in the cassette before use, using either a pencil or a ball-point pen,
simply insert the pen or pencil into the centre of spool and rotate to remove slackness. Depress the
STOP/EJECT button to open the cassette door.
Insert the cassette into the compartment with the open end facing upwards and the full reel on the left
hand side, push the cassette well down and close the door, be sure not to touch the tape surface, Set the
Function switch to “TAPE” position and press the cassette play button. To stop playback, press the
STOP/EJECT button once. To release the cassette, press the STOP/EJECT button again.
AUTO STOP
When the tape reaches the end during playback or recording, the built-in auto stop system will release
the depressed play, record keys. The auto stop system operates while recording from the built-in radio or
CD player, only the cassette function is brought automatically to stop mode and the radio or CD Player
will continue to play.
RADIO RECORDING
A.
Install a cassette tape.
B.
Set FUNCTION SWITCH to “RADIO” position. After selecting the desired band and tune the
TUNING KNOB to desired broadcast station. Then push down RECORD BUTTON and PLAY
BUTTON simultaneously.
C.
After recording the desired broadcast, depress the STOP/EJECT BUTTON lightly, and then set
FUNCTION SWITCH to “TAPE” position in order to listen to the recorded broadcast.
