ENGLISH
ENG 5
Display lighting
• You can set the brightness of the display panel by means of the
DIMMER
switch (19) on the back of the
device.
• The panel is brightly lit, when the switch is in the
BRIGHT
position. In the
DIM
position, the display panel will
fade.
Antennas
• For FM reception, this device is equipped with a FM wire antenna (26). Unwind the FM wire antenna and lay it
out.
Operating the radio
• Slide the
FUNCTION
switch (22) on the device to
AM
or
FM
. If the function switch is in the
AM
position, the
device is operating in the AM radio range. If the function switch is in the
FM
position, the device is operating in
the FM radio range.
• Select the desired radio station by means of the
TUNING
control (27).
• The LED indicator
FMST.
(C) will come on, if you are receiving a FM stereo station. Only FM stations are
broadcast in stereo. • A ferrite antenna has been built into this device for the AM reception. Orientate the device
in such a way that you will receive the stations with the best possible sound quality.
Setting the time
• After you have connected the power plug (25) to a power outlet, the time 12:00 will blink in the display (7).
• Hold the
CLOCK/ADJ.
button (18) down for 2 seconds. Either 24 H or 12 H will be shown in the display. To
change the time configuration, hold the
CLOCK/ADJ.
button (18) down again for 2 seconds. If you choose the
24-hour time format, the time of 0.00 will blink in the display panel. For the 12-hour time format, the time 12:00
will blink in the display.
• Press the
/MINUTE
button (12) to set the minutes and the
/HOUR
button (11) to set the hours. Confirm by
pressing the
CLOCK/ADJ.
button.
• If you select the 12-hour display, the LED indicator
PM
(D) will also be displayed for times after noon.
• If you would like to reset the time again later, press briefly on the
CLOCK/ADJ.
button. The time will blink in the
display. Set the time by means of the
/MINUTE
and
/HOUR
buttons and confirm by pressing the
CLOCK/ADJ.
button.
