EVCS_Central Controller_ENGCC01241 5.16
1.800.338.7337 / www.soundoffsignal.com
NOTICE:
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
Improper use or installation may void warranty coverage. To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support
. If you have questions regarding this product, contact
Technical Services
, Monday - Friday, 8 a.m. to 5 p.m. at
1.800338.7337
(press #4 to skip the
automated message). Questions or comments that do not require immediate attention may be emailed to
techservices@soundoffsigal.com.
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
3
Wiring and Interconnect Requirements for ENGCC01241 Central Controller
•High current interconnects require careful termination with the proper equipment.
WARNING! Poor crimp quality can cause significant heat build-up possible safety concerns.
Connector
manufacturers provide instructions on how to terminate properly in order to have a safe and reliable connection.
•Central Controller can switch up to a
total maximum of 100Amps.
User must configure outputs to not exceed this total current. Individual output switches are rated up to 10Amps each for
higher current loads,
but the total device current must not exceed 100Amps including the (4) constant on outputs.
The software warns when these limits are exceeded and user must
ensure that individual output limits and total device current limits are not exceeded in normal use.
•
Do not gang or parallel multiple outputs to drive a high current load.
Multiple 5Amp and 10Amp outputs must not be combined to achieve a higher current limit.
TERMINATION OPTION 2
Purchase individual connector components to terminate the wires at the connector.
TE (AMP) P/N:
1-480287-0
TE (AMP) P/N:
1-480424-0
TE (AMP) P/N:
350557-4
16pin Commercial MATE-N-LOK
Receptacle
4pin Commercial MATE-N-LOK Receptacle
Commercial MATE-N-LOK Socket Terminal
(16-18 AWG wire, used with both recep-
tacles)
•
Application Specification 114-1012: http://www.te.com/commerce/DocumentDelivery/DDEController?Action=showdoc&DocId=Spec
ifOr+Standard%7F114-1012%7FE%7Fpdf%7FEnglish%7FENG_SS_114-1012_E.pdf%7F350557-4
•PRO-CRIMPER III FRAME 354940-1: http://www.te.com/catalog/pn/en/354940-1?RQPN=354940-1
•DIE ASSY: 90575-2: http://www.te.com/catalog/pn/en/90575-2?RQPN=90575-2
•Actual terminal and housing needs may be different depending on application, wire type, etc.
•Extraction tool 1-305183-2: http://www.te.com/catalog/pn/en/1-305183-2?RQPN=1-305183-2
Pros:
•Consistent wire colors, clean install without butt-splices
Cons:
•Need to purchase crimper and train personnel
TERMINATION OPTION 1
Purchase accessory mating harness from SoundOff Signal
SoundOff P/N:
ENGHNK01 – two 12pin Mating Harnesses and one 4pin
Mating Harness
Pros:
•No need to terminate at the connector pins
Cons:
•Requires butt-splice or alternate connector
WARNING
Insulation
Crimp
Strip to this length
(drawn to scale)
0.156” to 0.187”
