1. IMPORTANT: Make sure that ALL stereo components including the
are turned OFF before proceeding.
2. Following the directions on “Preparing Speaker Wires”, strip and twist TWO lengths of speaker wire that will reach between the receiv-
er’s speaker terminals and the THP-CXB. Make these two lengths of wire only as long as is necessary to run between the two
components.
3. Connect one speaker wire to
the RIGHT ( ) and ( ) speaker terminals of the receiver or integrated amplifier. Then connect the
other end of this speaker wire to the RIGHT ( + ) and ( FROM AMPLIFIER terminals on the back of the THP-CXB. Use the tips
on determining speaker wire polarity to make sure that ( ) is connected to ( + ) and ( ) is connected to (
4. Connect the other speaker wire to the LEFT ( ) and ( ) speaker terminals of the receiver or integrated amplifier. Then connect
the other end of this speaker wire to the
LEFT ( + ) and ( ) FROM AMPLIFIER terminals on the back of the THP-CXB. As in step
3, double check polarity.
5. Connect the main left and right channel speakers to the THP-CXB “TO SPEAKERS” terminals.
6. Connect the Soundolier or other subwoofer to the round red and black “TO
terminals on the back of the THP-CXB.
Make sure that polarity is correct, using the
binding post for the ( ) connection and the RED binding post for the ( + ) con-
nection.
7. IMPORTANT: Consult the owner’s manual that
came with the subwoofer to determine if it is rated
at 4 ohms or 8 ohms. Then set the
“4 OHM 8 OHM” switch accordingly. If you are
using two subwoofers, refer to the section titled;
“Using
on page 4.
NOTE: See Section C: THP-CXB REAR PANEL
TOUR, OHM 8 OHM switch”, for additional
information on page 3.
8. You are now ready to put the THP-CXB and
subwoofer into use. Skip to the next section
titled:
THP-CXB FRONT PANEL MINI-
TOUR on page 10.
Amplifier Wiring
Hook-up for
Most Receivers
and Integrated
Ampllflers
:
.
,
.
