SoundPals DA-14, User Manual

DA-14 User Guide     

Page 11

Environmental Specifications and Dimensions 

Parameter 

Specification 

Dimensions 
(less connectors) 

5.2W x 1.62H x 6.625D  
13.2 x 4.1 x 16.8 cm 

Power 

375  mA  @  6 Vdc 

Operating Temp. 

10 – 50 

°

C 

Operating Humidity 

10 – 90% RH non-condensing 

Inside the Module 

In This Section 

This section provides instructions for opening and closing the SoundPals DA-14 module to gain 
access to the internal circuit board. 

NOTE 

The internal circuit board should only be removed from the module if you want to 
reset the jumpers. 

Before You Begin 

Check the following items before opening the module and attempting to remove the internal 
circuit board: 

  If required, remove the SoundPals module from the rack tray. 
  Disconnect the power supply from the front of the product. 
  Disconnect all input and output cables. 
  Perform the remaining steps 

only 

in a static free environment.  Make sure that 

you and 

the product 

are both grounded. 

The following tools are required: 

•

 #2 

Philips 

screwdriver 

Opening the Module 

Use the following steps to open the DA-14 module: 

1.  On the rear panel, remove the four Phillips screws from the four corners of the 

SoundPals module.   

2.  On the front panel, remove all Philips XLR mounting screws from the module. 
3.  On the front panel (if BNC connectors are present), remove the BNC nut(s) and 

associated lock washer(s).  

4.  Pulling the rear panel, carefully draw the internal circuit board and rear panel assembly 

from the housing. 

CAUTION 

If BNC connectors are present, keep the case horizontal so that the bushings 
stay with the connectors.   

5.  Set the housing and all mounting hardware in a safe place.