6
INSTALLING
THE SPL 6
MIDRANGE/
WOOFER
MOUNTING
THE SPL 6X
CROSSOVER
The SPL 6 Midrange/Woofer can be mounted on
the front or rear of a panel; gaskets are provided
for both options. The bolt hole configuration will fit
a variety of American, European and Asian OEM
patterns making it ideal for direct placement. Best
performance is achieved when the speaker is
securely mounted to a door panel or rear deck.
There should be no gaps between the speaker and
the mounting surface, as this will impair its low
frequency performance. Be certain that both the
panel and the speaker are securely mounted to
prevent unwanted vibration.
1) Mark the speaker location by using the
template provided.
2) Cut the opening and debur the edges with a
file.
3) Hold the speaker in place against the
mounting surface and mark the mounting bolt
holes.
6) Drill the appropriate size hole for the screws
provided.
7) Place the SPL 6 into the trim ring, make the
speaker wire connections, then install the
speaker/trim ring assembly to the panel using
The SPL 6X Passive Crossover can be mounted
in virtually any location inside the vehicle. Be
sure not to mount the SPL 6X outside the vehicle,
or in a location where it may be exposed to dirt or
moisture (e.g., the engine compartment, inside a
wheel housing, at the bottom of a leaky trunk,
inside a door).
60.pub
page 6
Friday, September 10, 1999 21:03
