ARS.1
PAGE 9
OWNER'S MANUAL
SYSTEM OPERATIONS
DISARM ALARM / UNLOCK DOORS
1. Press then release the Unlock Button on the remote transmitter.
2. The park lights will flash and the SIREN will chirp two times.
3. The alarm will disarm and the door’s will unlock.
4. The LEDs will stop flashing.
- If the system is in valet mode the doors will lock/ unlock but the SIREN will not chirp.
- The LEDs will stay on solid if the system is in valet mode.
See Valet / Service Mode in this manual for further information
NOTES:
- If the alarm is activated the first press of the unlock button will turn off the SIREN. Pressing
unlock again will disarm the alarm and unlock the door’s.
** Optional Feature may require additional parts and labor.
PRESS & RELEASE
Panic Mode
is a personal protection feature that allows you to activate your alarm from the
remote transmitter to draw attention to your vehicle if you feel threatened.
1. Press and HOLD the Lock Button for three seconds. The siren will activate and the
park light will begin to flash. Panic will stay active for 1 minute then turn off
.
2. Press the Lock or Unlock buttons to stop Panic Mode.
ACTIVATE PANIC MODE
PRESS HOLD
CAR FINDER MODE
This feature helps in locating your vehicle in a crowded parking lot. It allows you hear and see
your vehicle from a distance.
1. PRESS & HOLD The UNLOCK and TRUNK Buttons on the remote transmitter for
5 seconds. The SIREN will chirp 5 times and the park lights will flash 5 times.
PRESS & HOLD for 3 sec
+
PAGE 8
OWNER'S MANUAL
SYSTEM OPERATIONS
TRUNK RELEASE
1. Press then HOLD the Trunk Button on the remote transmitter.
2. The park lights will flash and the SIREN will chirp two times.
3. The system will disarm, unlock the doors then open the Trunk.
4. The LEDs will stop flashing.
NOTES:
- For safety, the trunk release will not active when ignition key is ON.
** Optional Feature may require additional parts and labor.
PRESS & HOLD
1. Press and release the Lock Button on the remote transmitter.
2. The park lights will flash and the SIREN will chirp one time.
3. The alarm will arm and the doors will lock.
4. The LED will start flashing within five seconds.
5. The alarm will trigger at this point if the door is opened of if the shock sensor is
triggered.
- If the system is in Service Mode the doors will lock/ unlock but the SIREN will not chirp.
- The LEDs will stay on solid if the system is in Service Mode.
See Valet / Service Mode in this manual for further information
NOTES:
- If the alarm is activated pressing the lock button on the remote will stop the SIREN from
sounding and the alarm will stay armed.
** Optional Feature may require additional parts and labor.
The LEDs can be programmed not to flash when the system is armed/ door’s are
locked by the remote transmitter.
ARM ALARM / LOCK DOORS
PRESS & RELEASE
ARS.1
