SYSTEM PROGRAMMING -
Menu 1
PAGE 10
INSTALL MANUAL
SYSTEM WIRING DETAILS
SYSTEM GROUND INPUT
JUMPER SELECTABLE PARK LIGHT OUTPUT (+ OR -)
HORN OUTPUT (-)
STARTER-KILL/ ANTI-GRIND OUTPUT
PINK
OUTPUT TO ACTIVATE IGNITION CIRCUIT
PINK/WHITE
SELECTABLE OUTPUT (DEFAULT SECOND IGNITION)
RED
30A HIGH CURRENT 12VOLT INPUT
PURPLE
OUTPUT TO ACTIVATE START CIRCUIT
RED
30A HIGH CURRENT 12VOLT INPUT
ORANGE
OUTPUT TO ACTIVATE ACCESSORY/ HEATER CIRCUIT
SYSTEM PROGRAMMING -
Menu 1
PAGE 11
INSTALL MANUAL
SYSTEM WIRING DETAILS
PIN-1 PURPLE Starter Output-
This wire will test 0V when the key is off, in the Accessory
position and when the Ignition is in the on position. The starter wire is 12volts during the start/
crank position only.
PIN-2 ORANGE Heater/Acc Output-
This wire will test 0V when key is off, 12volts in the ACC
and IGN positions and off during start/ crank position.
PIN-3 RED 12volt Input(30amp)-
This input supplies the 12volt power for the Ignition, Park
Lights and the Selectable output.
PIN-4 RED 12volt Input(30amp)-
This input supplies the 12volt power for the Accessory
and Starter outputs.
PIN-5 PINK/WHITE Selectable Output -
2nd Ignition, Accessory or Start output. Programmable.
Note: This output does not switch to default when the system is reset.
PIN-6 PINK Ignition Output-
This wire will test 0V in the off and Accessory positions the
switch to12volts in the Ignition and Start positions.
PIN-1 BROWN (-) Horn Output-
Connect to the vehicle’s horn wire.
PIN-2 ORANGE/BLACK Starter Kill/ Anti-Grind-
This wire can be connected to an additional relay to disable
the start circuit when the lock button is pressed. The output will also stay on when remote started, this will
prevent the starter motor from being re-engaged while the vehicle is running.
PIN-3 WHITE Jumper Selectable Park Light Output (+ or -)-
Connect to the vehicles positive park light
wire or change the jumper and connect to the vehicle negative park light wire. The default position of the jumper
is
Positive Park light Output.
PIN-4 BLACK
System Ground Input-
Connect to chassis ground.
6-PIN CONNECTOR
4-PIN CONNECTOR
RS.3
RS.3
WHITE
BLACK
ORANGE/BLACK
BROWN
