1- ORANGE Wire- Ground When Running (-)
Connect this wire to the your bypass modules negative turn on wire. When the remote
starter is activated this wire will switch to ground.
2- BLACK Wire- System Ground (-)
Connect this wire to the ground input on the bypass module.
3- N/A
3 PIN BYPASS CONNECTOR
GROUND OUTPUT
N/A
BLACK
ORANGE
GROUND WHEN RUNNING OUTPUT
T
.
his input is used to connect bypass modules using the data to data type
connection. There are 2 selection types. The default setting is set for FORTIN™
Bypass Module, the second is for IDATA™™ Bypass Modules
4 PIN DATA BYPASS
*The Thermistor must be connected before power-up to be detected by the system.
The thermistor can be installed in the engine compartment for engine temperature or
in
under the dash for interior temperature. The start trigger will activate the remote
starter when grounded.
2 PIN THERMISTOR/ START TRIGGER
SYSTEM PROGRAMMING -
Menu 1
PAGE 14
INSTALL MANUAL
SYSTEM WIRING DETAILS
SYSTEM PROGRAMMING -
Menu 1
PAGE 15
INSTALL MANUAL
INSTALLER NOTES
RS.3
RS.3
