SYSTEM PROGRAMMING -
Menu 1
PAGE 2
RS.3
INSTALL MANUAL
TABLE OF CONTENTS
QUICK VIEW WIRING DIAGRAM..........................................................3-4
Connector Pin Configuration
Antenna Connector
Park Light Jumper
INSTALLATION NOTES............................................................................5
TACH LEARNING......................................................................................6
Data Tach Mode
Tach/ Tachless Learn
Hybrid Mode
QUICK VIEW PROGRAMMING..............................................................7-9
Enter Program Mode
System Reset
Menu 1,2,3 & 4
SYSTEM WIRING DETAILS................................................................10-14
Connector Views
Wiring Description
INSTALLER NOTES.................................................................................15
Page for Installation Notes
TRANSMITTER PROGRAMMING...........................................................16
Adding/ Reprogramming Transmitter
Second Car Operation
PADLOC
DIAGNOSTICS.........................................................................................17
Diagnostic Chart
Diagnostic Memory
DOOR LOCK DIAGRAMS..................................................................18-19
Relay Diagrams
CONTACT INFORMATION.......................................................................20
SYSTEM PROGRAMMING -
Menu 1
PAGE 3
RS.3
INSTALL MANUAL
QUICK VIEW WIRE DIAGRAM
1
5
3
2
4
6
1
2
3
4
5
6
7
8
9
10
11
12
13
1
3
2
4
OUTPUT TO ACTIVATE
IGNITION CIRCUIT
THE
SELECTABLE OUTPUT* (DEFAULT 2ND IGN)
12VOLT/ 30 AMP MAIN POWER INPUT
OUTPUT TO ACTIVATE THE STARTER CIRCUIT
12VOLT/ 30 AMP MAIN POWER INPUT
OUTPUT TO ACTIVATE
ACCESSORY CIRCUIT
THE
SYSTEM GROUND INPUT
SELECTABLE PARK LIGHT OUTPUT (DEFAULT POSITIVE)
(-) HORN OUTPUT
AUXILIARY 1 OUTPUT/ PROGRAMMABLE OUTPUT
(-) 2ND ACCESSORY/ PROGRAMMABLE AUXILIARY 2 OUTPUT
AUXILIARY OUTPUT TO ACTIVATE TRUNK RELEASE
REARM OUTPUT (PULSE WITH LOCK & AFTER START)
NEGATIVE SECOND START OUTPUT
DISARM OUTPUT (PULSE WITH UNLOCK & BEFORE START)
NOT USED
DIESEL WAIT TO START (+ or -) / TRIGGER TO START
TACH DETECTION INPUT (CONNECT TO COIL, INJECTOR...)
BRAKE SWITCH INPUT (12VOLT WHEN BRAKE IS PRESSED)
HOOD PIN SWITCH (GROUND WHEN HOOD IS OPENED)
NOT USED
NOT USED
* The selectable output can be changed in the program mode to output as a 2nd Accessory or 2nd Start output.
Default output is second ignition.
This output does not change back to 2nd Ignition upon reset.
WARNING -NEVER INSTALL AN AUTOMATIC REMOTE START IN A MANUAL TRANSMISSION VEHICLE!
BLACK
WHITE
ORANGE/BLACK
BROWN
PINK
PINK/WHITE
RED
PURPLE
RED
ORANGE
ORANGE/BLACK
ORANGE/WHITE
RED/WHITE
GREEN/WHITE
PINK/WHITE
GREEN/BLACK
PURPLE
GRAY/BLACK
PURPLE/WHITE
GRAY
GREEN
BROWN
BLACK/WHITE
(-) STARTER KILL/ ANTI-GRIND OUTPUT
Status Led’s
Program Button