ST1952 Operation Manual
47
:STATe?
:FAIL?
Query state of limit test
Query test result (1=pass, 0=fail)
:CALCulate[1]
Use these commands to configure and control MXB and percent math calculations.
:FORMat <name>
Command syntax:
:CALCulate[1]:FORMat <name>
Command Parameter:
<name> = NONE
No calculations
MXB
Polynomial math calculation
PERCent
Percent math calculation
Query:
:FORMat?
Query programmed math format
Description:
This command is used to specify the format for the CALC1 math calculations. With NONE selected,
no CALC1 calculation is performed. With MXB or PERCent selected and enabled, the result of the
calculation is displayed. The calculated reading is refreshed every time the instrument takes a
reading.
:KMATh Commands
:MMFactor <NRf>
Command syntax:
:CALCulate[1]:KMATh:MMFactor <NRf>
Command Parameter:
<NRf> =
-100e6 to 100e6
Specify “m” factor.
Query:
:MMFactor?
Query “m” factor.
Description:
This command is used to define the “m” factor for the mx+b calculation.
:MBFactor <NRf>
Command syntax:
:CALCulate[1]:KMATh:MBFactor <NRf>
Command Parameter:
<NRf> =
-100e6 to 100e6
Specify “b” factor.
