ST1952 Operation Manual
11
2.2.2 Front Panel Menu Reference
A: MATH MENU
1: HI LIMIT
Set the high limit for limit testing
2: LO LIMIT
Set the low limit for limit testing
3: PERC REF
Set the reference value for PERCENT function
4: dB REF
Set the dB reference voltage value
5: dBm REF
Set the dBm reference impedance value.
6: MxB MSET
Set the M parameter for Mxb
7:
MxB BSET
Set the b parameter for Mxb
8:
CONTFLAG
Set the link reference for continuity function
B: TRIGger MENU
1: TRIG MOD
Set the trigger mode
2: HOLD WIN
Set the reading hold sensitivity band
3: HOLD CNT
COUNT of readings for reading hold
4:RDGS STOR
Data storage function is enabled
5:RDGS COUN
Set the data storage number
6:SCAN RDGS
Scan the saved data
C: SYStem MENU
1: BAUD RATE
2: BEEP START
3: KEY SONG
4: REVISION
5: ZERO CAL
6: TEMP TNST
7: PLACE 4/5
8:HANDLER:IO
9:SCALALLOW
Set the baud rate
Enable or disable the beep function
Enable or disable the key sound
Version number
Zero clearing calibration
Switch between degree centigrade °C and Fahrenheit degree °F
Function selection between 4½ and 5½ digits
Set the HANDLER interface and select the internal or external power
Enable or disable the manual calibration function
