ST1952 Operation Manual
69
Query:
:COUNt?
Query HOLD count.
Descripton:
This command is used to specify the count for HOLD. COUNt is the number of readings that are
compared to the “seed” reading during the HOLD process.
:STATe <b>
Command syntax:
:HOLD:STATe <b>
Command Parameter:
<b> = 0 or OFF
Disable HOLD
1 or ON
Enable HOLD
Query:
:STATe?
Query state of HOLD
Description:
This command is used to enable or disable HOLD.
6.3.12 TRIGger subsystem
These commands in this subsystem are used to configure and control trigger measurement function and
are summarized in Table 6-12.
Table 6-12 TRIGger Subsystem Commands Summary
Command
Function Description
Default
:TRIGger
:SOURce <name>
:SOURce?
Select control source
Query control source
IMMediate
0
:TRIGger
TRIGger subsystem commands are used for the instrument settings of trigger mode, trigger delay and
trigger a measurement.
:SOURce <name>
Command Syntax:
TRIGger:SOURce <name>
Command parameter:
<name> = IMMediate
instrument default setting is internal trigger
BUS
Triggered via RS232 interface
MANual
Press
Trig
in the front panel for Trigger
