24
3.2.10 Continuity
This section describes how to configure the continuity test from the front panel.
Step 1:
Configure the test leads as follows:
Step 2:
Press [Cont] on the front panel to open a menu that specifies whether the digital multimeter will beep to
indicate the continuity.
The continuity measurement method is as follows:
≤ 10 Ω Display the measured resistance and beeps (if the buzzer is enabled).
10 Ω ~1.2 kΩ Display measured resistance, no buzzer.
> 1.2 kΩ Dsplay OPEN (ON), no buzzer.
