63
7.2.10.9 SYSTem:COMMunicate:LAN:PORT
Description:
Set the port number of the network port TCP communication.
Syntax:
SYSTem:COMMunicate:LAN:PORT {<port>}
SYSTem:COMMunicate:LAN:PORT?
Parameters:
port number
Example:
SYST:COMM:LAN:PORT 45454
7.2.10.10 SYSTem:COMMunicate:LAN:SMASk
Description:
Set the subnet mask.
Syntax:
SYSTem:COMMunicate:LAN:SMASk {<smask>}
SYSTem:COMMunicate:LAN:SMASk?
Parameters:
Subnet mask
Example:
SYST:COMM:LAN:SMAS 255.255.255.0
7.2.11 SYSTem Subsystem - General Command
7.2.11.1 SYSTem:BEEPer[:IMMediate]
Description:
Issue a single beep
Syntax:
SYSTem:BEEPer[:IMMediate]
Parameters:
(none)
Example:
SYST:BEEP
7.2.11.2 SYSTem:BEEPer:STATe
Description:
Disable or enable the buzzer sounding during continuity, diode or probe hold measurements, or
when an error occurs on the current panel or remote interface.
Syntax:
SYSTem:BEEPer:STATe {ON|1|OFF|0}
SYSTem:BEEPer:STATe?
Parameters:
{ON|1|OFF|0}
Example:
SYST:BEEP:STAT OFF
7.2.11.3 SYSTem:CLICk:STATe
Description:
When the front panel button or softkey is pressed, the button beep can be disabled or enabled.
Syntax:
SYSTem:CLICk:STAT {ON|1|OFF|0}
SYSTem:CLICk:STAT?
Parameters:
{ON|1|OFF|0}
Example:
SYST:CLIC:STAT OFF
