68
CALCulate:SCALe[:STATe]?
Parameters:
{ON|1|OFF|0}
Example:
CALC: SCAL: STAT ON
7.2.15 CALCulate: LIMit subsystem
This subsystem takes limit tests for the measurement results.
7.2.15.1 CALCulate:LIMit:LOWer[:DATA]
Description:
Set the lower limit of the limit test
Syntax:
CALCulate:LIMit:LOWer[:DATA] <value>
CALCulate:LIMit:LOWer[:DATA]?
Parameters:
<value> set lower limit
Example:
CALC: LIM: LOW -50
7.2.15.2 CALCulate:LIMit:UPPer[:DATA]
Description:
Set the upper limit of the limit test
Syntax:
CALCulate:LIMit:UPPer[:DATA] <value>
CALCulate:LIMit:UPPer[:DATA]?
Parameters:
<value> set upper limit
Example:
CALC: LIM: UPP 50
7.2.15.3 CALCulate:LIMit[:STATe]
Description:
Enable or disable the limit test
Syntax:
CALCulate:LIMit [:STATe] {ON|1|OFF|0}
CALCulate: LIMit[:STATe]?
Parameters:
{ON|1|OFF|0}
Example:
CALC: LIM ON
7.2.15.4 CALCulate:LIMit:CLEar[:IMMediate]
Description:
Clear limit test results
Syntax:
CALCulate:LIMit:CLEar[:IMMediate]
Parameters:
(none)
Example:
CALC:LIM:CLE
7.2.16 CALCulate: AVERage Subsystem
This subsystem calculates measurement statistics.
