6
UTS1JC18MPN & UTS6JC18MPN
Cable preparation
1. Slide the backshell onto the cable allowing 50 cm at the end of the cable for stripping the cable. Make sure to orient each component as
shown in the UTS MPO Component details section.
2. Using the cable jacket strip tool, strip the jacket to the dimension given in figure below, exposing the kevlar strength members and fiber.
4. Fix the Kevlar using an adhesive tape on the “individual fibers” to facilitate the insertion of the crimp support.
5. Slide the crimp support (large diameter end first) over the fibers and the kevlar strength members until it bottoms on the cable outer jacket.
3. Using the shears, trim the kevlar strength members to the length given in figure below.
Fiber tube protection: 100±1 mm
Kevlar: 40±1 mm
UTS MPO Serie
s
|
BT319
Assembly instructions
Summary of Contents for UTS MPO Series
Page 1: ...ASSEMBLY INSTRUCTIONS UTS MPO Series BT 319...
Page 2: ......
