7
UTS1JC18MPN & UTS6JC18MPN
(Continued)
8. Before the instant adhesive begins to harden,quickly slide the ear clamp over the fiber, orient the Clamp according the picture.
Push the strength members back over the clamp until it bottoms on the rear flange of the support.
6. Separate the kevlar strength members in two groups. Use an adhesive tape to fix the kevlar strength members on the jacket.
7. Apply the instant adhesive on the fiber and cover the crimp support. (e.g. Loctite 480 PRISM).
9. Crimp the both ear of the Clamp using the Nipper. Remove the kevlar strength members using using the shears.
Check the good crimping by pulling manually.
UTS MPO Serie
s
|
BT319
Summary of Contents for UTS MPO Series
Page 1: ...ASSEMBLY INSTRUCTIONS UTS MPO Series BT 319...
Page 2: ......
