SERVICE
South Bend Tools
For Machines Mfd. Since 11/20
Model SB1099
-39-
S E R V I C E
Pairing Remote
Control & Receiver
The Model SB1099 is equipped with a remote
control receiver that can be programmed to
operate up to 16 separate controllers.
Avoid touching electrified parts inside receiver
while performing procedure below! Touching
electrified parts will result in personal injury
including but not limited to severe burns,
electrocution, or death. Use a wood dowel or
other non-conducting item to push button on
receiver.
1.
Remove switch cover to get a clear view of
remote receiver (see Figure 77).
Figure
Figure 77. Location of receiver in switch box.
. Location of receiver in switch box.
Receiver
Receiver
Pairing Remote
Items Needed
Qty
Phillips Head Screwdriver #2 ...............................1
Wood Dowel ...........................................................1
2.
Press and hold green ON button on remote
control (see Figure 78) until LED indicator
illuminates on remote receiver (see Figure
79).
3.
Press pairing button on receiver with a
non-conducting tool, then release when LED
indicator turns off (see Figure 79). Pairing
is complete.
Figure
Figure 79. Remote receiver.
. Remote receiver.
Pairing Button
Pairing Button
LED
LED
Indicator
Indicator
1.
Remove switch cover to get a clear view of
remote receiver (see Figure 77).
2.
Press and hold green ON button on remote
control for eight seconds, then wait for LED
indicator to flash three times.
Unpairing Remote
Figure
Figure 78. Remote control.
ON Button
ON Button
OFF Button
OFF Button
